Eden WT 800C Hybrid Head Bass Amplifier

  • Model: *WT 800
  • Shipping Weight: 35lbs
  • Manufactured by: Eden

$1,499.99

Eden WT 800C Hybrid Head

Since its introduction 12 years ago, the WT-800 World Tour has been the number one choice of our touring endorsers. Our new "C" version now boasts an improved cooling system and more power. Conservatively rated at 440 Watts (4Ω) per side with both channels driven, and 880W bridged into 8Ω and a whopping 1100 Watts bridged into 4Ω (with a minimum of 3dB of headroom), the WT800C is still the perfect choice for the touring professional. Standard features include: switchable automatic compression, mute, five-way semi-parametric tone control, electronic crossover, pre and post effect loops, stereo aux inputs, DI out with ground lift, level and pre-/post-EQ select, headphone out, tuner out, and a thermostatically controlled fan.

No-compromise, hand-built workmanship is Eden's m.o. The outstanding WT800 contains a tube hybrid stereo amplifier conservatively rated at 400 watts per side into 4(800W bridged into 8, 1100W bridged into 4) with 3dB of headroom. It also has has a -12dB input pad, switchableautomatic compression, 5-way semi-parametric tone control, mono pre- and stereo-post tone control effects loops, stereo aux inputs, a DI out with ground lift, headphone out, tuner out, and a thermostatically controlled fan. It's the perfect choice for the touring professional who demands excellence.
  • 440W per side into four ohms
  • 880W bridged into eight ohms
  • 3dB of headroom
  • -12dB input pad
  • Switchable automatic compression
  • Five-way semi-parametric tone control
  • Mono pre- and stereo-post tone control effects loops
  • Stereo aux inputs, a DI out with ground lift
  • Headphone out
  • Tuner out
  • Thermostatically controlled fan

Eden WT800 World Tour Bass Amp Head
The powerhouse Eden WT800 World Tour Bass Amp Head features a tube hybrid stereo amplifier design with a conservative rating of 440W per side into 4 ohms, 880W bridged into 8 ohms, and 3dB of headroom. If you need to move a lot of air, this is a bass head that will do it. The Eden WT800 bass amp head also has a -12dB input pad, switchable automatic compression, 5-way semi-parametric tone control, mono pre- and stereo-post tone control effects loops, stereo aux inputs, a DI out with ground lift, headphone out, tuner out, and a thermostatically controlled fan.

The WT800B delivers 300 watts RMS output @ 8 Ohms, 440 watts @ 4 Ohms and 550 watts @ 2 Ohms (per channel). In Bridge Mode, it delivers 880 Watts @ 8 Ohms and 1100 Watts @ 4 Ohms. All modes of operation have +3dB of headroom. This amplifier also features a thermostatically controlled, active cooling system with built-in thermal safeties.

FRONT PANEL FEATURES
Input Jack – Designed to accept a standard _ inch mono phone plug. For best results use a high quality shielded cable to connect your instrument to the amplifier. The input is buffered and will handle standard passive, high level active, and piezo input signals.

Gain Control – Regulates the first gain stage of the preamplifier and controls the amount of signal available to the system.
Set Level Indicator – This light helps the user set the appropriate amount of gain. When set properly, the indicator should light on your loudest/lowest notes. We’ll go over this in more detail later in the manual.
Enhance Control – Called the “Magic Knob” by some, this complex control simultaneously boosts the very low bass, upper middle, and high frequencies while putting a dip in the lower middle frequencies. It is flat when set to its minimum level (fully counterclockwise).
Input Pad – Depressing this switch engages a –10dB pad. This feature is useful for basses that have a very hot signal level
.


Add to Cart:



This product was added to our catalog on Monday 23 September, 2002.

Copyright © 2014 BassExchange/GuitarBassPro/Amp-shop. Designed by 12leaves.com
Your IP Address is: 54.145.191.14
wastrong template