Just about any passive type volume pedal or expression pedal will work with the Mojo Vibe. Of course some better than others, due to the value of the pot in the pedal. The ideal value would be a 100K reverse log taper. But I have found that many other values will work satisfactorily. To conserve space the Mojo Vibe uses a ¼" stereo tip, ring, sleeve switching jack for the controller input. You can use it as is with expression pedals where the cord is already connected to the pedal such as Roland, Boss and other keyboard expression pedals. To use a passive volume pedal you will need a special cord that consists of a ¼" stereo plug on one end and splits into two mono ¼" plugs. These are the same cables used in the channel inserts on mixing consoles and are readily available at most music stores. Chorus / Vibrato Switch Ok, so it?s not really a chorus as we know them, but we?ll stay with the original terminology. This uses a short bat (so it?s hard to break off) miniature toggle switch to decide the output. Either the original "chorus" / Uni-Vibe sound or a wild vibrato can be chosen with this switch. Volume Control Adjust the output to match the input level. Intensity Control Adjust the depth or "intensity" of the effect, also effects the bias of the sweep to some degree. Speed Control Adjusts the speed of the sweep. From a slow rolling phase to a bubbling, watery, pulsing throb. True Bypass with LED that pulses in time with the speed setting.
